Behringer 2500 Series Quick Start Manual

Quick Start Guide
FILTAMP MODULE 1006
Legendary 2500 Series 24 dB Low-Pass
VCF and VCA Module for Eurorack
Controls
(1)
(4)
(5)
(6)
(7)
(8)
(12) (13) (14) (15) (16) (17)
FILTER – Adjusts the cutoff frequency for the filter.
(1)
FILTER RESONANCE – Boosts the resonance frequencies
(2)
selected with the Filter knob, potentially causing
VCF oscillation.
AMPLIFIER GAIN – Controls the level of the VCA.
(3)
KEYBOARD knob – Attenuate the voltage connected to
(4)
the KYBD input, which controls the cutoff frequency of
the filter.
IN B knob – Adjusts the level of the signal connected to
(5)
the IN B input.
CV 2 to VCF knob – Attenuate the voltage that is passed
(6)
from the CV 2 input to the VCF.
IN A knob – Adjusts the level of the signal connected to
(7)
the IN A input.
CV 1 to VCF knob – Attenuate the voltage that is passed
(8)
from the CV 1 input to the VCF.
V 1.0
(2) (3)
(9)
(10)
(11)
EXPONENTIAL/LINEAR switch – Select between a linear
(9)
or more natural exponential VCA response.
CV 2 to VCA knob – Attenuate the voltage that is passed
(10)
from the CV 2 input to the VCA.
CV 1 to VCA knob – Attenuate the voltage that is passed
(11)
from the CV 1 input to the VCA.
IN A – Connect an input signal via 3.5 mm TS cable.
(12)
IN B – Connect an input signal via 3.5 mm TS cable.
(13)
KYBD – Connect a voltage that can be used to control the
(14)
VCF frequency.
CV 1 – Connect a voltage that can be used to control the
(15)
VCF frequency or VCA level.
CV 2 – Connect a voltage that can be used to control the
(16)
VCF frequency or VCA level.
OUT – Send the processed signal to other modules via
(17)
3.5 mm TS cable.
Power Connection
The unit comes with the required power cable for connecting
to a standard Eurorack power supply system. Follow these
steps to connect power to the module. It is easier to make
these connections before the module has been mounted into
a rack case.
1. Turn the power supply or rack case power off and
disconnect the power cable.
2. Insert the 16-pin connector on the power cable into the
socket on the power supply or rack case. The connector has
a tab that will align with the gap in the socket, so it cannot
be inserted incorrectly. If the power supply does not have
a keyed socket, be sure to orient pin 1 (-12 V) with the red
stripe on the cable.
3. Insert the 10-pin connector into the socket on the back of
the module. The connector has a tab that will align with the
socket for correct orientation.
4. After both ends of the power cable have been securely
attached, you may mount the module in a case and turn on
the power supply.