Wiring - Mitsubishi Electric 800 Series Instruction Manual

3.2

Wiring

Use the network connection cable which supports 12.0 Mbps communication.
1.
Strip off the sheath of the PROFIBUS communication dedicated cable and wind wires and shield cables to use.
Strip off the sheath for the below length. If the length of the sheath peeled is too long, a short circuit may occur with
neighboring wires. If the length is too short, wires might come off.
Wire the stripped cable after twisting it to prevent it from becoming loose. In addition, do not solder it.
Use a ferrule terminal as necessary.
When using the ferrule terminal, use care so that the twisted wires do not come out.
20
WIRING
Cable stripping length
5 mm
Damaged Crumpled tip
Unstranded
wires
Wires are not inserted
into the sleeve