To Get Digital Audio From The Component - Bose 3.2.1 GS Series III Owner's Manual

S
ETUP

To get digital audio from the component

For a component that is already connected to the
media center, you can make a digital audio connection
too.
For this higher quality audio, you need a digital audio
cable that works with your component. Such cables are
available at most electronics stores.
1. Identify the digital connector on your component
as either an Optical or Coaxial connector.
2. Be sure to use the right cable for this connector.
Optical OR
Note: If your component has an Optical and a Coaxial
connector, use either one but not both.
20
Svenska
Coaxial
Optical
Coaxial
Nederlands Français Italiano
3. Connect one end of your digital cable to the digital
AUDIO OUT connector on your component.
Be sure to keep the red and white audio cable
connected. This allows you to hear the audio if the
program audio is not digital or the digital signal is
interrupted.
4. Locate the appropriate digital AUDIO IN connector,
labeled D, on the system media center.
You can make:
• up to 3 coaxial connections
• up to 2 coaxial and one optical connection
Note: The media center Optical connector is factory
set to work with a cable or satellite box. If your Optical
component is neither of those, you need to select your
component in an on-screen System menu. See
"Getting digital audio from a source" on page 45.
Deutsch Español English