Eureka Sphinx 3+ User Instructions

User instructions:
Sphinx 3+/ 5+
Directly after purchase
1. Choose the right tent pegs
Important: Different camping grounds require different pegs (plastic for clay; metal
for rocky; wood for sand). Your Eureka! tent contains 1 type of top quality pegs for
general usage. To ensure secure setup of your tent, when you expect to camp on
different grounds during your trip(s), please buy the appropriate pegs at your dealer's
in advance.
2. Do a trial-set up of your tent.
Please set up your tent prior to your first trip to ensure you are familiar with the
setup and the tent is in proper condition.
Tent set-up instructions
Important: Inspect the chosen site and clear all sharp and/or protruding objects that
can damage the tent floor. Be sure the site will offer proper drainage of rainwater
away from the tent. When choosing a site try to pitch the tent in a shaded area.
1. Unroll the tent and spread out the fly on the ground.
2. Assemble the shock-corded pole segments ensuring the inserts are fully
connected to avoid pole damage.
3. Slide the longer pole through the middle pole sleeve. Repeat using the
shorter poles in the other sleeves (always push through sleeves as pulling
can separate the connections, resulting in breakage when the pole is
flexed.) The tent is now flat with the poles in their sleeves.
4. Insert the pole tips into the grommets on one of the sides. Move to the
opposite side, flex the poles forming hoops, and insert the pole tips into
their grommets. The tent is still flat but all hoops are now assembled.
Europe distribution: Nigor Net B.V., Utrecht, The Netherlands
ENGLISH VERSION
5. Stake out the tent at the corners of the sleeping end with 2 pegs.
Lift the tent hoops and stretch them apart. Stake the tent with
another 2 pegs at the opposite end. The tent is now up.
6. Secure the tent with a peg at each pole location and (adjust tension
at all buckle locations). Stake out the guy lines to stabilize the tent
in windy conditions.
Tent care
We strongly advise you to read the Eureka! Tent Care Leaflet (included in
the peg bag) before first use!!

Floor protection: We recommend the use of a thin groundsheet or floor
saver with any tent for added protection from abrasion. The floor saver
should be about 10cm. (4 inches) from the tent edge to avoid the
possibility of channelling water beneath the tent.

Damaging substances: Fuels can damage tents as can DEET found in
many insect repellents.
 Exposure to sun: The sun's UV rays can be harmful even with technical
advances in fabrics. Prolonged exposure could result in fading and
possibly fabric disintegration. Do not leave a tent up longer than
necessary.
 Cleaning: Clean tent fabric, poles and zippers with lukewarm, clean
water after every use. Never use detergents, washing machines or
dryers (also see warranty leaflet).

Tent storage: It is important that you store the tent in a dry and cool
condition. If you put the tent away in the carry bag while it is wet, even
for a short time, it may become affected by mildew, which can damage
the coating.

Seams: All major seams are factory taped. Over time seams could
experience delamination. Simply clean the seam and apply seam sealer
that can be purchased at most outdoor stores.
T+31 88 0999899 F+31 30 280 9509 E info@nigor.net U www.eurekaeurope.com