Disc Playback - Yamaha CinemaStation DVD-S30 Owner's Manual

■ Disc playback

Problem
A disc cannot be inserted into
this unit
Some button operations do not
work
Playback does not start or
stops immediately when
pressing p
An audio or subtitle language
does not switch
No subtitles appear
A viewing angle does not
switch
DVD videos cannot be copied
with the VCR
Picture looks poor
The TV (monitor) does not show
the picture properly
The screen size of the TV or
monitor looks strange
(the image is distorted or the
subtitle is missing)
The TV shows overlapped
picture partly
The disc is ejected without an
operation
Cause
This unit is not turned on.
This unit is in the initialization process.
This unit is not ready for disc loading.
Another disc is already inserted into this
unit.
You may be trying to reload the ejected disc
by pushing it.
Some discs do not support certain functions.
The disc may be dirty.
The disc loaded into this unit may be not
compatible.
When moved this unit from a cold place to
warm one, condensation may be form on the
disc reading lens.
The disc may not support the multi-language
feature.
The subtitle may be set to "OFF".
The disc may not contain subtitle data.
When using the A-B Repeat feature
(page 12), the subtitle may not appear at the
parts other than the selected section.
The disc may not support the multi-angle
feature.
You may be trying to copy a copy-protected
DVD.
In some cases, picture may look poor while
fast forwarding or reversing, but this is not a
defect.
In the Setup menu, "TV SYSTEM" does not
match the specifications of your TV.
The progressive scan mode may be used with
a TV that does not support it.
"TV DISPLAY" in the Setup menu or the
setting of your TV does not match the size of
your TV.
When the progressive scan mode is activated,
image with a 4:3 aspect ratio are played on a
16:9 wide television screen.
The disc content does not match the
progressive scan mode due to the editing
method or other conditions.
The disc loaded into this unit may be not
compatible.
ADDITIONAL INFORMATION
Solution
Turn on this unit and insert the disc after "NO
DISC" appears on the front panel display.
Wait for a while and insert the disc after "NO
DISC" appears on the front panel display.
Wait for a while and insert the disc after "NO
DISC" appears on the front panel display.
Eject the disc from this unit, and then insert the
disc you want to play back after "NO DISC"
appears on the front panel display.
or p, or remove the disc from the disc
Press
loading slot fully and then insert it once again.
Wipe the disc clean.
Make sure you use a disc supported by this unit.
(page iii)
Wait for one to two hours, then try again.
Make sure you use a disc that supports the
multi-language feature.
Select a subtitle language you want to display.
(page 15)
Make sure you use a disc with subtitle data.
Cancel the A-B Repeat feature. (page 12)
Make sure you use a disc that supports the
multi-angle feature.
Most commercially available DVDs include
copy protect features. You cannot make a copy
of these DVDs.
Carry out the procedure "Step 2: Setting the TV
color system". (page 8)
Disable the progressive scan mode. (page 23)
Change "TV DISPLAY" in the Setup menu
(page 23) or the setting of your TV.
Change "TV DISPLAY" in the Setup menu.
(page 23)
If you cannot adjust the ratio, turn off the
progressive scan mode. (page 23)
Disable the progressive scan mode. (page 23)
Make sure you use a disc supported by this unit.
(page iii)
25