Preset Tuning - Yamaha EMX-100CD Owner's Manual

TUNING OPERATION
CD CHANGER RECEIVER EMX–100CD
DISC
1 2 3
POWER
PHONES
4, 2 2
CD
1 2
1 2
6 7
6 7
A B
TIME PROG
MODE REPEAT RANDOM
DISC SKIP
CENTER/REAR
TEST FLAT
/DELAY
ECHO
MUSIC
LEVEL
POWER
SLEEP
VOLUME
3, 1 1 3, 5
INPUT SELECTOR VOLUME
VCR/LD-TV/CD/TUNER/TAPE•MD/AUX
OPEN/
CLOSE
DISC
CHANGE
RANDOM REPEAT TIME MEMORY AUTO/MAN'L
PROGRAM
HOUR MIN TIME ADJ TIMER
PRESET/TUNING/BAND A/B/C/D/E
MUSIC
ECHO ECHO
MIC MIC MIXING
USER MEMORY DISPLAY
MIN MAX
4, 2 2
3 4 5
3 4 5
8 PRESET
8 9 0
3, 1 1
C D E
+
I0
TUNER
OPEN/CLOSE
STOP PLAY/PAUSE
INPUT
PROGRAM USER
DISPLAY

Preset tuning

This unit can store station frequencies selected by tuning
operation. With this function, you can select any desired
station by only calling the corresponding preset station
number. Up to 40 stations (8 stations x 5 groups) can be
stored.
To store stations
(Example: To store a station to A1)
1
Tune in to a desired station.
(Refer to the previous page for tuning procedure.)
2
Press the tuner MEMORY button.
* "MEMORY" and "PRESET" will flash on the display for
about 5 seconds.
3
Select a desired group (A – E) of preset stations by
pressing the A/B/C/D/E button confirming it on the
display, before "MEMORY" goes out.
(In this case, select group A.)
4
Select a preset station number by pressing the
button repeatedly before "MEMORY" goes out.
(In this case, select "1".)
5
Within about 5 seconds, press the tuner MEMORY button
again.
PRESET
The currently displayed station
has been programmed to A1.
* In the same way, program other stations to A2, A3 ... A8.
* You can program more stations to the preset station
numbers of other groups in the same way by selecting
other groups in step 3.
To recall a preset station
1 1
Select a group of preset stations by pressing the
A/B/C/D/E button.
2 2
Select the desired preset station number by pressing the
or button repeatedly.
Notes
•
A new setting can be programmed in place of the former
one.
•
For presets the setting of the AUTO/MAN'L button is
stored along with the station frequency.
For easier operation
By using the preset station number buttons and the
A,B,C,D,E selector buttons on the remote control transmitter,
a preset station number and a group can be selected directly.
E-21
or
TAPE 1
AUTO
MHz