Changing Brightness Of The Display - Yamaha CDX- 590 Owner's Manual

Changing brightness of the display

CDX-890, CDX-590
You can change the brightness of the display (or turn off the illumination) by pressing the DIMMER button.
During play
Normal illumination
Dim
"OFF"
* While the display illumination is off,
the AUTO DISPLAY OFF indicator
on the front panel is illuminated.
CDX-490
If desired, you can change brightness of the display
in three degrees by pressing the DIMMER button.
When you listen with headphones
Connect the headphones to the PHONES jack and adjust the
volume by using the OUTPUT LEVEL button. At that time,
note that this adjustment will also vary the signal level output to
the amplifier.
CDX-890 only
* If the FIXED (LINE OUT) terminals on the rear of this unit
are connected to the amplifier etc., the use of the OUTPUT
LEVEL button will not vary the signal level output to the
amplifier.
Open/close the control door
When it is not necessary to operate controls inside the control
door, close the door.
To open the door
During stopped or paused
DIMMER
AUTO
DISPLAY OFF
CDX-890 only
To close the door
Normal illumination
Dim
Dim
(The AUTO DISPLAY OFF indicator lights up.
In this state, if a disc is played, the display
illumination will be turned off.)
Normal illumination
DIMMER
Slightly dim
Dim
PHONES
– +
OUTPUT LEVEL
11