Net/Usb Menu - Yamaha RX-N600D Owner's Manual

SET MENU

4 NET/USB MENU

Use this menu to adjust the network and USB system
parameters.
4 NET/USB MENU
. A)NETWORK
B)PLAY STYLE
C)INFORMATION
[ ]/[ ]:Up/Down
[ENTER]:Enter
■ Network settings
Use this feature to view the network parameters (IP
address, etc.) or to change them manually.
A)NETWORK
.
DHCP
IP
SUBNET
GATEWAY 192.168.000.001
DNS (P) 192.168.000.001
DNS (S) 000.000.000.000
SET
[ ]/[ ]:Up/Down
[ENTER]:Enter
Note
The above display is an example.
DHCP DHCP
When this parameter is set to "ON", network parameters
for "IP", "SUBNET", "GATEWAY", "DNS (P)" and
"DNS (S)" obtained from a DHCP enabled router are
displayed. If DHCP server function is not available, set
this parameter to "OFF" to configure the network
parameters manually.
Choices: ON, OFF
IP address IP
Use this parameter to specify an IP address assigned to
this unit. This value must not duplicate the one used for
other devices in the target network.
Subnet mask SUBNET
Use this parameter to specify the subnet mask value
assigned to this unit.
y
For most of the cases, the subnet mask value can be set as
"255.255.255.0".
Default gateway GATEWAY
Use this parameter to specify the IP address of the default
gateway.
90
En
A)NETWORK
ON
192.168.000.002
255.255.255.000
>CANCEL
Primary DNS server DNS (P)
Secondary DNS server DNS (S)
Use this parameter to specify the IP address of the primary
and secondary DNS (Domain Name System) servers.
Note
If you have only one DNS address, enter the DNS address in
"DNS (P)". If you have two or more DNS addresses, enter one of
them in "DNS (P)" and another in "DNS (S)".
1
Press u / d on the remote control repeatedly
and then press ENTER to select and enter
the desired network parameter.
Note
When "DHCP" is set to "ON", you cannot select and adjust
any other network settings. To specify the other parameters,
you need to first set "DHCP" to "OFF".
2
To specify the parameter, press u / d repeatedly
to change the number and press j / i to select
the digit to change.
3
Press ENTER to confirm the parameter.
4
Repeat steps 1 through 3 to configure each
network parameter.
5
Select "SET" and then press ENTER to finish
configuration.
Note
In case you have changed your network configuration, you may
need to reconfigure the network settings again.
y
You can reset the network settings of this unit to the initial factory
settings by using "N-RESET" in the advanced setup menu (see
page 95).