2 Functional overview
2
Functional overview
Position control is a control mode in which the motor moves the load to a specified target
position.
The servo driver can be controlled via RTEX from any host controller which supports RTEX
communication. This Quick Start Guide explains how to wire and configure the servo driver
and the host controller to get your system up and running.
Use the Positioning table configurator PM7 (RTEX) in Control FPWIN Pro 7 to configure the
FP0H RTEX unit.
Example
The host controller is an FP0H PLC with an FP0H RTEX unit. It is connected to a MINAS
A6N servo driver by a standard network cable.
(1) MINAS A6N driver
(2) Load to be moved
(3) 24 VDC power supply
(4) Network cable
(5) FP0H PLC and RTEX unit
Data transmission between motion control unit and servo driver via network cable
6
(1)
(2)
(3)
(4) (5)
QS2004_V1.0_EN