Table of Contents
Advertisement
Technical data
Stacker relocation
The stacker must be moved by authorized personnel only .
In order to ensure that the stacker operates reliably after
moving it to a new location, consider the following guidelines:
The new location must provide minimum clearances around
the stacker. These clearances are shown in the diagram
which is located in the Technical data section of this
manual.
The flooring must be capable of supporting at least 100 lb.
(45.5 kg) for the stacker and an additional 650 lb. (295 kg)
for the attached printer.
The new location must be well ventilated and must maintain
a consistent room temperature. Extreme temperature or
humidity changes can affect the stacker.
Power source receptacles must be properly grounded.
Stacker 1000 Operator Manual
Technical data
Technical data
inches (3101 mm x 2974 mm)
96 inches (2438 mm) from the floor to the
nearest overhead obstruction, within the floor space
requirements
Once installed, the Stacker 1000 can be moved
in order to access the printer media drawers.
With printer: 122 inches x 117
8
Advertisement
Table of Contents
