Release Notes; Sets; 6204 Specific; Copying Arch-E Size Prints - Xerox FREEFLOW ACCXES FIRMWARE 12.7 B 114 Firmware Release Notes

6 Release Notes

The following information supplements the 12.5 customer user guides.

6.1 Sets

For 600 DPI engines (6030, 6050, 6050A, and 6204) the maximum number of ARCH E sized
documents that will collate reliably in a set is 150. If the documents will not collate properly, one
copy of the set will be printed only. This is for sets created using the scanner as well as printed
sets submitted across the network.

6.2 6204 Specific

6.2.1 Copying ARCH-E size prints

To maximize copying of ARCH-E size prints always copy them using the preset output format
ARCH-E. When copied in synchro mode it is likely that ARCH-E documents will scan as 1220mm
and will incur unneeded pauses between printing pages. The 6204 IOT will pause between pages
which are greater than ARCH-E (48 inches 1219 mm) in length for the fuser to come all the way
back to full temp even if it is in the nominal fuser temperature range.

6.2.2 Specifying titleblock for copies

When making a copy on the 6204 multi-function system which is intended to be folded you must
specify the titleblock as seen through the facedown page. The example below shows the
titleblock in the lower left corner:
6204 Scanner
Document
Page 10