Xerox DocuPrint N24 System Administrator Manual page 151

Table 3.14 Token Ring Menu functions (continued)
Menu Item and Function
Default Gateway
Set the four byte Default Gateway
address. The available values are:
xxx.xxx.xxx.xxx
.
Where xxx = 000 to 255
This item only appears if IP Address Res.
is set to
Control Panel
For this item (after Step 3), Item
Up moves the cursor to the right
through the displayed Default Gateway
address and Item Down
the cursor to the left. This allows you to
change characters within the string
rather than having to reenter the entire
string.
With the cursor displayed under a
character, Value Up increments
the value of that character and Value
Down
decrements the value.
Keystrokes
1. Press Menu Up
Down
2. Press Item Up
Down
3. Press Value Up
Down
.
4. Press Value Up
Down
of the character above the
moves
cursor. The value is incremented
or decremented by 1 each time
the key is pressed. Holding
down Value Up
Down
scrolling through the values.
5. To change other characters in
the Default Gateway address,
press Item Up
Down
respectively through the
character string, then press
Value Up
Down
of the character above the
cursor (as in Step 4).
6. When you have completed
setting the Default Gateway
address, press Enter
will see:
7. Press On Line
or Menu
Menu s
until you see:
Toke n R ing Me nu
or Item
Toke n R ing Me nu
until you see:
Defa ult Ga tew ay
or Value
Defa ult Ga tew ay=
. You will see:
xxx.xxx.xxx.xxx
or Value
Defa ult Ga tew ay=
to change the value
xxx.xxx.xxx.xxx
or Value
causes continuous
Defa ult Ga tew ay=
xxx.xxx.xxx.xxx
or Item
to scroll right or left
or Value
to change the value
Toke n R ing Me nu
Defa ult Ga tew ay
. You
. You will see:
Read y
Chapter 3: Using the Control Panel
Token Ring Menu
Display
Table 3.13 Page 9 of 12
3-73