CAMDEN inVISION CV-500PPK-V.2 Installation Instructions Manual page 4

Program Group of Card and PIN Code
1. Press *.
2. Enter the 6 digit master code (for the first use, the master code default is 000000).
3. Press * or present the Master Card.6 audible beeps are emitted and the LED flashes green and red to confirm
entry into programming mode.
4. Press 1, then * to program a sequential group of card + PIN code. 1 audible beep is emitted and the LED flashes
green.
5. Enter the number of cards to program, to a maximum of 99 Cards and Pin codes programmable in one group.
6. Press *. 1 audible beep is emitted and the LED stops flashing.
7. Enter the user number and then press * to confirm. The first sequential card will start from the user number
entered. 1 audible beep is emitted and the LED lights in green. If one of the user number is unavailable, the LED
flashes orange and 4 audible beeps are emitted, then the LED lights in green.
8. Present the first card in front of the CV500PPK-V.2 reader and enter the 4 digit Pin cod. 1 beep is emitted and
the LED flashes green and red. Or enter the last 6 digit code (decimal number) of the first card from the
sequential card group and press *, then enter the 4 digit Pin code. 1 beep is emitted and the LED flashes green
and red.
9. Press # to exit from the programming mode. 6 beeps confirm the reader is in standby mode.
NOTE: The card and pin code programming done by CV-500PPK-V.2 is using and incremental method.
1 Beep
Green
LED
flashing
*
1
Program New Master Code or Master Badge
1. Press *.
2. Enter the 6 digit master code (for the first use, the master code default is 000000).
3. Press * or present the Master Card.6 audible beeps are emitted and the LED flashes green and red to confirm
entry into programming mode.
4. Press 2. Then * to enter in the master code or a master card menu. 1 audible beep is emitted and the LED
flashes green.
5. Enter the new 6 digit master code or present a master badge. 1 beep is emitted and the LED lights green and
red.
6. Press # to exit from the programming mode. 6 beeps confirm the reader is in standby mode.
1 Beep
Green
LED
*
No. of
Cards 00-99
5502 Timberlea Blvd.,
Mississauga, ON Canada L4W 2T7
1 Beep
Green
LED
*
User Number
000-499
www.camdencontrols.com
Toll Free: 1.877.226.3369
Installation Instructions
CV-500PPK-V.2
Present 1st
sequential card of
the group
Enter 4 digit
PIN code
Enter the last 6
digit code of the
first card from
the sequential
card group
File: CV-500PPK-V.2_NF-Man_Rev1.doc
Revised: March 8, 2011
Part No.: 40-82B131
1 Beep Green
and Red LED
flashing
#