Making Hot Milk (Not Frothed); Cleaning The Cappuccino Maker After Use; Making Hot Water; Cleaning - DeLonghi ECAM22.32 Series Instructions For Use Manual

9. Add the milk froth to the cup of coffee prepared previously.
The cappuccino is ready. Sweeten to taste and, if desired,
sprinkle the froth with a little cocoa powder.

Making hot milk (not frothed)

To make hot milk without froth, proceed as described in the
above section, making sure the cappuccino/hot milk ring of
the cappuccino maker is positioned upwards in the "HOT MILK"
position.

Cleaning the cappuccino maker after use

Clean the cappuccino maker each time you use it to avoid the
build-up of milk residues or blockages.
Danger of scalding!
When cleaning the cappuccino maker, a little hot water is
delivered. Avoid contact with splashes of water.
1. Let a little water run for a few seconds by rotating the
steam knob to the I position. Then turn the steam knob to
the 0 position to stop the flow of hot water.
2. Wait a few minutes for the cappuccino maker to cool down.
To remove the cappuccino maker turn it outwards and slide
it down (fig. 16).
3. Move the cappuccino/hot milk ring upwards (fig. 17).
4. Slide the nozzle downwards (fig. 18).
5. Make sure the two holes shown by the arrows in fig. 19 are
not blocked. If necessary, clean with a pin.
6. Replace the nozzle, move the ring downwards and put the
cappuccino maker back on the nozzle (fig. 20), turning it
and pushing it upwards until it is attached.

MAKING HOT WATER

Danger of scalding!
Never leave the machine unsupervised while hot water is being
delivered. As shown below, stop delivery of hot water when the
cup is full.
The cappuccino maker becomes hot while hot water is being
delivered and must be held by the black ring only.
1. Place a container under the cappuccino maker (as close as
possible to avoid splashes) (fig. 15).
2. Turn the steam knob to the I position (fig. 5). "HOT WATER"
is displayed and delivery begins.
3. Stop by turning the steam knob to the 0 position.
Please note :
If "Energy Saving" mode is active, you may have to wait a few
seconds before the hot water is delivered.

CLEANING

Cleaning the machine

The following parts of the machine must be cleaned regularly:
- coffee grounds container (A14),
- drip tray (A18) and condensate tray (A15),
- water tank (A10),
- coffee spouts (A13),
- pre-ground coffee funnel (A6),
- inside of the machine, accessible after opening the infuser
door (A11),
- infuser (A12).
Important!
• Do not use solvents, abrasive detergents or alcohol to clean
the machine.
You do not need to use chemical products to clean
De'Longhi superautomatic coffee machines.
• None of the components can be washed in a dishwasher.
• Do not use metal objects to remove encrustations or coffee
deposits as they could scratch metal or plastic surfaces.

Cleaning the coffee grounds container

When "EMPTY GROUNDS CONTAINER" is displayed, the grounds
container must be emptied and cleaned.
Unless you clean the grounds container, the above message will
continue to be displayed and the appliance cannot be used to
make coffee. To clean (with the machine turned on):
• Remove the drip tray (fig. 21), empty and clean.
• Empty the grounds container and clean thoroughly to
remove all residues left on the bottom.
• Check the red condensate tray and empty if necessary.
Important!
When removing the drip tray, the grounds container must be
emptied, even if it contains few grounds.
If this is not done, when you make the next coffees, the grounds
container may fill up more than expected and clog the machine.

Cleaning the drip tray and condensate tray

Important!
If the drip tray is not emptied regularly, the water could overflow
and seep inside or around the machine.
This could damage the machine, the surface it rests on or the
surrounding area.
The drip tray is fitted with a floating level indicator (red)
showing the level of water it contains (fig. 22).
Before the indicator protrudes from the cup rest, the drip tray
must be emptied and cleaned.
To remove the drip tray:
13