Raymarine HYPERVISION HV-100 Installation Instructions Manual page 27

• Do NOT overtighten the bolt. Overtightening may cause damage to the transducer.
1. Position the transducer assembly in the transom bracket, ensuring that the ratchet grooves in the
transom bracket are aligned with the ratchet grooves in the hanger bracket.
2. Slide the M6 metal washer over the M6 hex (Allen) bolt.
3. Slide the supplied M6 hex (Allen) bolt through the transom bracket hole.
4. Place the M6 locking nut into the captive area on the mounting bracket and hold in position.
5. Using a 5 mm Hex wrench ((Allen key), tighten the bolt onto the locking nut, until the transducer
stays in position, but can still be adjusted (tilted) by hand.
6. Tilt the transducer so that the bottom face of the transducer will be parallel with the waterline
and tighten the hex bolt until the hanger is held firmly in place.
The transducer position will be adjusted further during testing.
Installation 27