Table of Contents
Advertisement
Cabling
Display Installation
Attention: The cable entrance at
the rear and the plugs must remain
dry.
The displays should be mounted inclined
backwards, so that the LCD will be read
slightly from below. Otherwise the readability
will be degraded at night.
The autopilot display or the compass dis-
play respectively, should be mounted within
reach of the helmsman.
Installation has to be made on a flat sur-
face to avoid bending the display housing.
Bus Cable
AP Display
Log
BUS
Steering
Wheel
ÿþýüû
û
Bus Power Cable
(11...40 Volts)
Fuse 2A
white = Plus
brown = GND
Bus terminator plug to be installed at the
most distant point from the bus power cable.
Do not install more than one bus termina-
tor. The second one is installed within the bus
power plug.
Log Sensor
Bus, Power (blue)
NMEA (red)
Wind Sensor
Wind
Jumbo Displays
B us terminator
Electrical Specifications
Autopilot
Cockpit Display: 25...50 mA @ 11...40 Volts
Jumbo Display:20...45 mA @ 11...40 Volts
Steering Wheel: 15...40 mA @ 10,5...40 Volts
Autopilot Computer: 35...70 mA @ 9...40 Volts
Flux Gate Sensor:
Sonic Heading Gyro:
Wind Sensor:
Log Sensor:
Echo-Box w/ Sensor:
The lower current is for the higher voltage.
30
Display
Sensor
Display
Wind Sensor
Sensor
Bus, Power (blue)
NMEA (red)
Jumbos
Bus
(with illumination: 35...90 mA)
(with illumination: 25...75 mA @ 11..40 Volts)
45 mA
5 mA
2 mA
2 mA
50 mA
Log Sensor
Jumbo bus ca-
ble (10m)
Advertisement
Table of Contents
