Guitar Tuner; Declaration Of Conformity; Factory Reset - Marshall Amplification CODE50 Owner's Manual

GUITAR TUNER

Pressing the PRE FX and AMP Section Switches (#15 & #16 in this manual) together
accesses the guitar TUNER:
• Pluck a string and the note you are playing will display.
• Tune the string until the name of the note you wish to tune to appears on the screen.
• The bar will move to the left if the note is lat. The bar will move to the right if the note is
sharp.
• When the bar is dead centre, that string is tuned to the displayed note.
• Press EXIT/STORE to exit the Tuner.

FACTORY RESET

Performing a factory reset will return CODE's Presets back to when it was new.
Before performing a factory reset, be sure that you want to overwrite all of your personal
!
Presets.
To perform a factory reset:
• Power OFF the ampliier using the ON/OFF switch (#14 in this manual).
• Whilst holding down the AMP Section Switch, turn the power ON.
• The screen will display a notiication that the ampliier is about to be returned to its
factory settings.
• If you are sure that you want to perform a factory reset, press and hold the EXIT/STORE
switch to conirm.
• If you do not want to restore the factory presets, pressing any other switch will cancel the
factory reset operation and boot the ampliier as normal.
ENGLISH

DECLARATION OF CONFORMITY

Marshall Ampliication Plc,
Denbigh Road,
Bletchley,
Manufacturer: Milton Keynes,
Bucks,
United Kingdom
MK1 1DQ
Kind of equipment: Audio Equipment
Type designation: CODE25, CODE50
We, Marshall Ampliication Plc, declare under our sole responsibility that the above listed products complies with the following
Directives:
1. EMC Directive 2004/108/EC;
2. Low Voltage Directive (LVD) 2006/95/EC;
3. R&TTE Directive 1999/5/EC.
The following harmonised standards have been applied:
• EN 55013:2013
• EN 55020:2007+A11:2011
1. EMC
• EN 61000-3-2:2014
• EN 61000-3-3:2013
2. LVD • EN 60065:2002 + A1:2006 + A11:2008 + A2:2010 + A12:2011
Health &
• EN 62479:2010
Safety
• EN 60065:2002 + A1:2006 + A11:2008 + A2:2010 +A12:2011
(Article 3(1)(a))
3. R&TTE • ETSI EN 301 489-1 V1.9.2:2011
EMC
(Article 3(1)(b)) • ETSI EN 301 489-17 V2.2.1:2012
Spectrum
• ETSI EN 300 328 V1.9.1:2015
(Article 3(2))
Signature: Name: B. Moon
Name of the responsible party: U.S.MUSIC CORP.
Address of the responsible party: 1000 Corporate Grove Drive, Byffalo Grove, lllinois 60089-450, United States of America.
Telephone number of the
800-877-6863
responsible party:
Name of equipment: MD116D Guitar Ampliiers
Model No.: CODE25, CODE50
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation.
ENGLISH
Date: 1st January 2016
16