Siemens SINUMERIK 840D Operation/Programming Manual page 407

8
10.04
112210
Explanation
Response
Remedy
112211
Explanation
Response
Remedy
112300
Explanation
Response
Remedy
112301
Explanation
Response
Remedy
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition
Tool axis cannot be reselected. Insufficient NC memory.
If you select another tool axis, you must generate a new NC program.
You must save the old NC program first and then generate the new
one. There is not sufficient NC memory available at this point to store
the new program.
Alarm display
The new tool axis selection is not implemented.
You must create free space in the NC memory corresponding to at
least the space required by the new program (e.g. by deleting
programs you no longer need).
System unable to process tool preselection. Insufficient NC
memory.
Before a tool preselection can be processed, you must generate a
new NC program. You must save the old NC program first and then
generate the new one. There is not sufficient NC memory available at
this point to store the new program.
Alarm display
The system does not process the preselected tool.
You must create free space in the NC memory corresponding to at
least the space required by the new program (e.g. by deleting
programs you no longer need).
Tool management strategy 2 impossible.
Magazine is not fully loaded
The magazine is not fully loaded with tools. In the magazine of tool
management type 2, the number of tools specified in machine data
18082 has to be created.
Power ON alarm
Start-up: Set up correct selection of tools
Tool management strategy 2 impossible.
Magazine is not sorted according to tool list
The magazine list is not sorted according to the tool list. The tools in
the magazine of tool management concept 2 must be ordered
according to T number.
Power ON alarm
Start-up: Define tools in magazine locations according to T number.
Alarms and Messages
8.2 Alarms in ShopMill
8
8-407