Selecting/Deselecting The Work Offset In The Manual Area - Siemens SINUMERIK 840D Operation/Programming Manual

2
Operation
2.14 Work offsets

2.14.3 Selecting/deselecting the work offset in the Manual area

Jog
Selecting a work offset
Cycle Start
Deselecting the work offset
Cycle Start
2-166
Select the "T, S, M" softkey in "Machine Manual" mode.
The "T,S,M" window opens.
Position the cursor on parameter "Work offset" and press the
"Alternat." softkey until the work offset you require appears.
Press the "Cycle Start" key.
The set work offset is activated.
The active work offset is also displayed in the "WCS" window.
e.g. WO1
The offset values entered in the "Work offset" menu are also taken
into account in the workpiece coordinate system display WCS (work).
Place the cursor on parameter "Work offset" and press the
"Alternat." softkey until " - " appears in the field.
Press the "Cycle Start" key.
An active work offset is deselected.
SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition
2
10.04
 Siemens AG, 2004. All rights reserved