Lighting And Shutdown - Ferroli OPERA Series Instructions For Use, Installation And Maintenance

1.3 Lighting and shutdown

Boiler lighting
Press the On/Off button (detail 14 - fig. 1).
Display v.01
Burner Controller 1 v.01
fig. 7 - Boiler lighting
Settings
Contrast adjustment
To adjust the display contrast, press the contextual button 2 and the OK button together. Then press the button ref.
5 of fig. 1 to increase the contrast or the button ref. 7 of fig. 1 to decrease it.
Setting the Date and Time
Reach the screen shown in fig. 8, navigating in the menu and following the path "USER MENU
Setting". Press the navigation buttons 5 and 7 to select the value and modify it with the contextual buttons 1 and 2. Con-
firm with the OK button.
128
Press the contextual button 1 to select the language,
confirming it by pressing "OK".
Press the contextual button 3 to stop FH mode.
If none of the two selections described above is made,
proceed as follows.
•
•
•
•
Set date
24 / 09
2013
to select
to confirm
fig. 8 - Setting the Date
cod. 3541R960 - Rev. 00 - 09/2019
For the following 300 seconds the display will show
FH which identifies the heating system air venting
cycle.
The display also shows the firmware version of the
cards.
Open the gas cock ahead of the boiler.
When the message FH disappears, the boiler is
ready to operate automatically in case of a room
thermostat demand.
1 5
2
7
OPERA
"Settings" "Date
EN