Assembly - Husqvarna 230iB Operator's Manual

• Do not connect the battery charger terminals to
metal objects as this can short circuit the battery
charger.
• Use approved wall sockets that are not damaged.
Safety instructions for maintenance
WARNING:
warning instructions that follow before you
do maintenance on the product.
• Remove the battery before you do maintenance,
other checks or assemble the product.
• The operator must only do the maintenance and
servicing shown in this operator's manual. Speak to
your servicing dealer for maintenance and servicing
of a larger extension.
• Keep all nuts, bolts and screws tight to be sure the
product is in safe working condition.
Introduction
This section describes how to assemble and adjust the
product.
WARNING: Before you assemble the
product, read the safety chapter and the
assembly instructions.
To assemble the blower tubes
Note: Apply water-based lubricant on the end of the
tubes to make assembly easier.
• Attach the blower nozzle to the tube until the tab (B)
goes into the hole (A). Make sure that the blower
nozzle and the tube are locked together.
A
1516 - 002 - 22.07.2020
Read the

Assembly

B
• Replace worn or damaged parts.
• If you do not do maintenance, it decreases the life
cycle of the product and increases the risk of
accidents.
• Special training is necessary for all servicing and
repair work, especially for the safety devices on the
product. If not all checks in this operator's manual
are approved after maintenance, speak to your
servicing dealer. We guarantee that there are
professional repairs and servicing available for your
product.
• Only use original spare parts.
SAVE THESE
INSTRUCTIONS
To attach the scraper tool
The scraper tool can be used to loosen leaves and other
unwanted material for easier cleaning.
• Attach the scraper tool to the blower nozzle until the
tab (A) goes into the hole (B). Make sure that the
scraper tool and the tube are locked together.
B
A
9