Heating/Cooling Times & Heating Temperatures - White Rodgers 1 F 78 Installation Instructions Manual

PROGRAMMING YOUR THERMOSTAT
7
CONTINUED FROM FIFTH PAGE
However, you may use the same heating and cooling tempera-
tures for consecutive time periods. You can choose start times,
heating temperatures, and cooling temperatures independently
for each day programs (for example, you may select 5:00 AM and
70 as the 1st period heating start time and temperature on
Monday, then select 7:00 AM and 76 as the 1st period cooling
start time and temperature on Monday). Use the table at the
bottom of the page to plan your program time periods and the
temperatures you want during each period. You may also want to
look at the sample program table to get an idea of how the
thermostat can be programmed.
Entering Your Program
Follow these steps to enter the heating and cooling programs you
have selected.
Set Current Time and Day
1. Press TIME button once. The display will show the hour only.
EXAMPLE:
2. Press and hold either
hour and AM/PM designation (AM begins at midnight; PM
begins at noon).
Heating/Cooling Schedule Plan (Factory Program)
Start Time
Period
1ST 6:00 AM
2ND 8:00 AM
3RD 5:00 PM
4TH 10:00 PM
1ST 6:00 AM
2ND 8:00 AM
3RD 5:00 PM
4TH 10:00 PM
PERIOD 1
HEAT
Time Temp
Mon
Tues
Wed
Thur
Fri
Sat
Sun
PM
or until you reach the correct
SAMPLE
ALL DAYS OF THE WEEK
Temperature
70 F
62 F
70 F
62 F
78 F
85 F
78 F
82 F
Heating/Cooling Schedule Plan
PERIOD 2
COOL HEAT
Time Temp Time Temp
3. Press TIME once. The display window will show the minutes only.
EXAMPLE:
4. Press and hold either
minutes.
5. Press TIME once. The display will show the day of the week.
6. Press
7. Press RUN once. The display will show the correct time and
room temperature alternately.
Enter Heating/Cooling Times and Heating
1. Move the SYSTEM switch to HEAT.
2. Press PRGM once. MO, the abbreviation for Monday, will be
displayed. Also displayed are the currently programmed start
time for the 1st heating period and the currently programmed
temperature fo rthe 1st heating period (flashing).
EXAMPLE:
This example shows that for the 1st Monday heating period,
the start time is 6:00 AM, and 70 is the programmed tempera-
ture (this example reflects factory preprogramming).
3. If the temperature displayed in not the temperature you want
for Monday"s period 1, press
temperature is displayed.
4. To change the displayed start time to the time you have
selected for Monday's heating period 1, press TIME once (the
programmed time will flash). Press
selected time is displayed. The time will change in 15 minute
increments.
5. Press PRGM once. The currently programmed start time and
heating setpoint temperature for Monday's heating period 2
will be displayed.
6. Repeat steps 3 and 4 to select the start time and heating
temperature for Monday's 2nd heating period.
7. Repeat steps 3 through 5 for Monday's 3rd and 4th heating
period. Monday's heating program is now complete.
PERIOD 3
COOL
HEAT
Time Temp
Time Temp
www.white-rodgers.com
or until you reach the correct
or until you reach the current day of the week.
Temperatures
MO TU WE TH FR
AM
or
COOL HEAT
Time Temp Time Temp
until the correct
or until your
PERIOD 4
COOL
Time Temp