Know Your Snow Thrower - White Outdoor 235 Operator's Manual

Fuel Cap
Chute Assembly
Shave Plate
Choke Lever
OFF CHOKE
Activating choke control closes the choke plate on
carburetor and aids in starting engine. Refer to the engine
manual packed with unit for more detailed instructions.
Primer
Depressing primer forces fuel directly into
engine's carburetor to aid in cold-weather
starting. Refer to engine manual packed with
unit for more detailed instructions.
Ignition Key
Ignition key must be present, inserted in
key switch, and in the "ON" position for
engine to start.
Recoil Starter
The starter handle is used to manually start the engine.
Electric Starter Button
Pressing the electric starter button engages the
engine's electric starter when plugged into a 120V
power source
Electric Starter Plug
Requires use of a two-prong outdoor extension cord
(packed with the snow thrower) and a 120V power
source/wall outlet.
Spark Plug Cover
Remove spark plug cover to access spark plug.
Auger Control
Electric Starter Button
Key
Auger
Figure 4-4
Auger
When engaged, the augers rotation draws snow into
ON
the auger housing and throws it out the chute assembly.
Rubber paddles on the augers also aid in propelling the
unit as they come in contact with the pavement.
Auger Control
Located on the upper handle, the auger control is used
to engage and disengage drive to the auger. Squeeze
PRIMER
the control against the upper handle to engage auger;
release it to disengage.
Chute Assembly / Chute Handle
PUSH FOR A Rotate the chute assembly to the left or right using chute
COLD ENGINE
handle. Pitch of the chute assembly controls angle at
OFF
which the snow is thrown. Loosen wing knob on side
Stop
ON
of the chute assembly before pivoting chute assembly
Run
IGNITION
upward or downward. Retighten the knob once desired
position has been achieved.
Shave Plate
The shave plate maintains contact with pavement as
(If so equipped)
the snow thrower is propelled, allowing snow close to
pavement's surface to be discharged.
Fuel Cap
Remove gas cap to add fuel. This unit runs on a mixture
(If so equipped)
of fuel and oil. Do NOT operate the snow thrower without
first reading the Tecumseh engines operator's manual for
instructions regarding proper fuel and engine oil.
NOTE: This unit may include a fuel plug, which is only
used during assembly to keep dirt and debris out of fuel
tank. Discard the fuel plug before filling the fuel tank.
7
Starter Handle
Primer
Spark Plug Access
Chute Handle
Choke Lever
4
Know
Your Snow
Thrower
IMPORTANT:
This unit runs on a
mixture of fuel
and oil. Do NOT
operate the snow
thrower without first
reading the Tecumseh
engine operator's
manual for instructions
regarding proper fuel
and engine oil mixture.
NOTE:
This unit may
include a fuel plug,
which is only used
during assembly to
keep dirt and debris
out of fuel tank.
Discard the fuel plug
before filling the
fuel tank.