Laser Audio/Visual Alerts; Vg-2 Audio/Visual Alerts; Alert Priority; Reset Features - Whistler 1770 Owner's Manual

LASER/VG-2 ALERTS

Laser Audio/Visual Alerts

When a laser signal is detected the word "Laser" and sig-
nal strength is displayed, the audio alert is continuous for
a minimum of 3 seconds. Example:
The more "|||" the closer the laser source.

VG-2 Audio/Visual Alerts

Note: You must turn this feature on in option select mode before
it will detect VG-2.
When a VG-2 signal is detected, the detector "hides" its own
radiated signal and becomes undetectable by the VG-2.
Text message confirms detection of VG-2.
Every 30 seconds, the detector checks for a VG-2 signal. If
a VG-2 signal is still present, the unit continues to hide and
repeats the VG-2 alert. If no signal is detected, two beeps
are provided, indicating an "all clear" condition. During
VG-2 Alert X, K, and Ka band signals cannot be received.
(Reference page 26 for VG-2 information.)

Alert Priority

When two or more signals are received at the same time,
the alert priority is:
1. NWR Alert (NWR STBY)
2. Laser
3. Speed Radar
4. Safety Radar
5. NWR weather reports (NWR ON)
Example:
If X band is alerting, then suddenly VG-2 is detected, the
VG-2 warning will override the X band alert.
22

RESET FEATURES

Reset Features
All user features can be reset to factory settings.
• Unplug Power Cord from unit.
• Press and hold the Power and Quiet buttons.
• Plug Power Cord into unit.
• Wait for 2 beeps.
• Release the Power and Quiet buttons. Unit is now reset.
1. Audio to level (6).
2. Display reads Highway.
3. Dim/Dark Mode to full illumination of display.
4. Auto Quiet Mode OFF.
5. VG-2 Detection Mode OFF.
6. Voice ON.
7. Safety ON.
8. Vehicle Battery Saver ON.
9. Full Power Up sequence.
10. Default TONE 3.
11. Unit ON or OFF.
12. All Band ON.
13. NOAA in Standby Mode.
14. SQ (Squelch) ON
23