Miele PG 8061 Operating Instructions Manual page 100

Frequently asked questions
Problem
Fault 403-405
Fault 406-408
Fault 412-414
Check drainage
Fault 433
Fault 438
Fault 492, 504, 541
Fault 550
100
Possible cause and solution
If Check water intake
controls will check the water intake every 30 seconds. If no
water has entered the dishwasher after three attempts, one
of these fault numbers appears in the display and the
program will be canceled.
Open the water supply valve all the way.

Turn the dishwasher back on.

Select the desired program.

Press the Start/Stop button.

Water inlet fault.
One of these numbers will appear in the display if the flow
pressure is too low and the program will be cancelled.
The flow pressure at the water intake point is too low

(see "Technical data"). Contact Miele Service for advice.
Water inlet fault.
One of these numbers will appear in the display if the flow
pressure is too high and the program will be cancelled.
The flow pressure at the water intake point is too high

(see "Technical data"). Contact Miele Service for advice.
The water outlet is restricted. There might be water in the
wash cabinet.
Clean the filter combination (see "Cleaning and care").

Clean the drain pump (see "Frequently asked

questions").
Clean the non-return valve (see "Frequently asked

questions").
Remove any kink or loop in the drain hose.

The door was obstructed when closing and cannot be
drawn into the final closed position.
Remove the obstruction from the vicinity of the door.

Heavy objects positioned in front of the dishwasher
prevent the Comfort Door Lock from automatically opening
the door.
Do not place any (heavy) objects in front of the

dishwasher door.
Fault during program start. There may still be water in the
wash cabinet.
Clean the filter combination (see "Cleaning and care").

Clean the non-return valve (see "Frequently asked

questions").
The Waterproof system was activated.
Close the water supply valve.

Contact Miele Service.

has appeared in the display, the