Lap/Shoulder Belt Operating; Adjustable Upper Shoulder Belt Anchorage; Lap/Shoulder Belt Untwisting - Alfa Romeo Stelvio 2019 User Manual

Table of Contents

Advertisement

Lap/Shoulder Belt Operating

Instructions
1. Enter the vehicle and close the door.
Sit back and adjust the seat.
2. The seat belt latch plate is above the
back of the front seat, and next to your
arm in the rear seat (for vehicles
equipped with a rear seat). Grasp the
latch plate and pull out the seat belt.
Slide the latch plate up the webbing as
far as necessary to allow the seat belt to
go around your lap.
3. When the seat belt is long enough to
fit, insert the latch plate into the buckle
until you hear a "click."
Seat Belt Latch Plate Inserted Into Seat
Belt Buckle
96
4. Position the lap belt so that it is snug
and lies low across your hips, below your
abdomen. To remove slack in the lap belt
portion, pull up on the shoulder belt. To
loosen the lap belt if it is too tight, tilt the
latch plate and pull on the lap belt. A snug
seat belt reduces the risk of sliding under
the seat belt in a collision.
5. Position the shoulder belt across the
shoulder and chest with minimal, if any
slack so that it is comfortable and not
resting on your neck. The retractor will
withdraw any slack in the shoulder belt.
6. To release the seat belt, push the red
button on the buckle. The seat belt will
automatically retract to its stowed
position. If necessary, slide the latch
plate down the webbing to allow the seat
belt to retract fully.

Lap/Shoulder Belt Untwisting

Procedure
Use the following procedure to untwist a
twisted lap/shoulder belt.
1. Position the latch plate as close as
possible to the anchor point.
2. At about 6 to 12 inches (15 to 30 cm)
above the latch plate, grasp and twist the
seat belt webbing 180 degrees to create
a fold that begins immediately above the
latch plate.
3. Slide the latch plate upward over the
folded webbing. The folded webbing
must enter the slot at the top of the latch
plate.
4. Continue to slide the latch plate up
until it clears the folded webbing and the
seat belt is no longer twisted.
Adjustable Upper Shoulder Belt
Anchorage
In the driver and outboard front
passenger seats, the top of the shoulder
belt can be adjusted upward or
downward to position the seat belt away
from your neck. Push or squeeze the
anchorage button to release the
anchorage, and move it up or down to the
position that serves you best.
Adjustable Upper Shoulder Belt
Anchorage
Adjustable Anchorage

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents