Husqvarna ECA850 Operator's Manual page 5

Hide thumbs Also See for ECA850:
Table of Contents

Advertisement

Available languages

Available languages

Listen out for warning signals or shouts when
you wear hearing protection. Always remove
your hearing protection as soon as the engine/
motor stops.
If the cutting attachment is attached to a battery
power unit, the front guard must be installed.
To install the front guard, battery power
Refer to
units on page 7 .
Make sure that your hands and feet do not come
near the cutting attachment when the engine/
motor is on.
When the engine/motor is switched off, keep
your hands and feet away from the cutting
attachment until it has stopped fully.
Always keep the cutting attachment near the
ground.
Always do edging at full throttle/speed.
Always slow the engine/motor to idle speed after
each work operation. Long periods at full throttle/
speed without any load on the engine/motor (i.e
without the resistance that the cutting attachment
exerts on the engine/motor when you are using
the product) can lead to serious engine/motor
damage.
Be especially careful when you pull the edger
towards you during work.
If any object is hit or if vibrations occur stop the
product immediately. If you have a gasoline
operated product, remove the spark plug cap
from the spark plug. If you have a battery
operated product, remove the battery. Check that
the product is not damaged. Repair any damage.
Sometimes grass or stones can get trapped in
the cutting attachment guard and cutting
attachment. Always stop the engine/motor before
you clean it.
Personal protective equipment
WARNING: You must use approved
personal protective equipment whenever
you use the procuct. Personal protective
equipment cannot eliminate the risk of
injury but it will reduce the degree of
injury if an accident does happen. Ask
your dealer for help in choosing the right
equipment. Please read the operator's
manual carefully and make sure you
understand the instructions before using
the procuct.
Gloves should be worn when necessary.
Wear hearing protection that provides adequate
noise reduction.
1153 - 001 - 22.08.2019
WARNING: Listen out for warning
signals or shouts when you are
wearing hearing protection. Always
remove your hearing protection as
soon as the engine/motor stops.
WARNING: Long-term exposure to
noise can result in permanent
hearing impairment. So always use
approved hearing protection.
Always wear approved eye protection. If you use
a visor then you must also wear approved
protective goggles. Approved protective goggles
must comply with the ANSI Z87.1 standard in the
USA or EN 166 in EU countries. Blows from
branches or objects that are thrown can damage
the eyes.
Wear sturdy, non-slip boots.
Always wear heavy, long pants, boots, gloves,
and a long-sleeve shirt. To reduce the risk of
injury associated with objects being drawn into
rotating parts, do not wear loose clothing,
scarves, jewelry, etc. Secure hair so it is above
shoulder level.
A breathing mask should be used when there is
a risk of dust.
Always have a first aid kit nearby.
5

Advertisement

Table of Contents
loading

This manual is also suitable for:

Esa850

Table of Contents