LEVELING
THE WASHER
The tub of your new washer
spins at very high
speeds.
To minimize
vibration,
noise, and unwanted
movement,
the floor
must be o _evel, solid surface.
NOTE: Adjust the _eveHng feet only as far as
necessary
to _evel the washer.
Extending
the feveling
feet more
than
necessary
can cause the
-washer to vibrate.
NOTE: Before installing the
washer, make sure that the floor
is clean, dry and free of dust, dirt,
water and oil so the washer feet
cannot slide easily. Leveling feet
that move or s_ide on the floor can contribute
to
excess vibration
and noise due to poor contact with
the floor,
All four leveling feet must rest solidly on the floor.
Attempt to rock the washer from corner to corner
to make sgr.e that^all four leveling feet are in firm
contact wtth the tloor,
I. Position the washer in its final location, taking
special care not to pinch, strain, or crush the
water and drain lines. Place a level across the top
of the washer,
• To check if the washer is level from side to side,
place a level on the back edge of the lid.
f
Sde
J
2. Adjust the leveling feet, Turn clockwise to raise
the washer or counterclockwise
to lower it.
f
Wrong
Righf
3. To make sure that the was:her is properly
level,
open: the lid and look from above to see if the
the level.
11