Accuwash; Temperature Control System - Whirlpool LSW9245EQ0 Use And Care Manual

S
ELECTING A FABRIC SPEED AND CYCLE TIME
Rinse and Spin cycle
When washing heavily soiled clothes, or washing
special-care items, you may find an extra rinse and
spin is needed. An extra spin only may help shorten
drying times for some heavy fabrics or special-care
items by removing excess water.
•
For a rinse and spin, turn the Cycle Control knob to
Rinse Only.
•
For a spin only, turn the Cycle Control knob to Spin
Only.
NOTE: Rinse water temperature and spin speed will
be the same as your previous wash cycle unless
new selections are made.
Soak Cycle
The Soak cycle features brief periods of agitation
and soak time to help remove heavy soils and stains
that need pretreatment. Select 10 or 22 minutes of
soak time, depending on the soil level of your load.
For high speed agitation, set the Fabric/Speed
Select to Cotton or Perm Press.
For low speed agitation, set the Fabric/Speed
Select to Delicates.
For intermittent agitation, set the Fabric/Speed
Select to Handwashables.
•
Select a Soak/Prewash Temperature to match the
type of fabric and soils in your load.
•
Use the amount of detergent or presoak additive
recommended by manufacturer.

ACCUWASH

TM
Your washer uses the ACCUWASH automatic
temperature control in the Normal wash cycle and
Rinse and Spin cycle. ACCUWASH maintains a
uniform water temperature by regulating incoming hot
and cold water. This helps eliminate undissolved
detergent and ensures consistent cleaning results.
•
Select a wash water temperature of 75°F (24°C) for
items that bleed, handwashables, or lightly soiled
items.
•
Select a wash water temperature of 100°F (38°C) for
cleaning whites and bright colors or moderately to
heavily soiled items.

TEMPERATURE CONTROL SYSTEM

.
( CONT
)
•
The Soak cycle automatically advances into the
Pre-Wash cycle.
•
After the cycle ends, set a new wash cycle.
Pre-Wash Cycle
The Pre-Wash cycle features 4 minutes of agitation
to help remove heavy soils and stains that need
pretreatment. This cycle provides additional washing
prior to the desired cycle. Because the Pre-Wash
cycle does not rinse, a new wash cycle should be
selected after the Pre-Wash cycle ends.
For high speed agitation, set the Fabric/Speed
Select to Cotton or Perm Press.
For low speed agitation, set the Fabric/Speed
Select to Delicates.
For intermittent agitation, set the Fabric/Speed
Select to Handwashables.
•
Select a Soak/Prewash Temperature to match
the type of fabric and soils in your load.
•
Use Pre-Wash for heavily soiled loads that need
more than one wash.
•
After the cycle ends, set a new wash cycle.
75
Cold
Cold
Cold
OPERATING YOUR WASHER
75
75
100
Cold
9