Other Operating Instructions; For A Rinse And Spin; For A Drain And Spin; For A Soak - Whirlpool LA638OXP Use & Care Manual

Other operating instructions
For a rinse and spin For a drain and spin
You may need an extra rinse and
spin for heavily soiled loads which
need more detergent. (Extra de-
tergent can require an extra rinse.)
l
Push Control Knob in.
l
Turn clockwise to any
l
on the dial.
See above drawing.
l
Pull Control Knob out.
l
The washer will fill to selected
level; agitate 2 minutes; drain
and spin.
Your washer can be set to drain
and spin out water.
* Push Control Knob in.
l
Turn clockwise to the bar just before
OFF in any cycle. See above
drawing.
l
Pull Control Knob out.
l
The washerwill drain and spin.
For agitation and spin speeds in each cycle,see pages 6-9.
For
a soak
For best results, use warm water
for soaking stained laundry. Hot
water can set stains.
l
Use recommended amount of
detergent or presoak product.
l
Push Control Knob in.
l
Turn clockwise to point at a number
in the SOAK Cycle!
l
Pull Control Knob out to start washer.
l
When the cycle is over, add de-
tergent for the next selected wash
cycle. The SOAK Cycle should
always be followed by a Wash
Cycle.
Important: See additional care
information on page 7 of your
"Laundry Guide!'
l
Set the washer and start the next
selected wash cycle.
*To start soak with agitation, the Cycle Control Knob
must point to a number in the SOAK Cycle.
Cleaning the lint falter
Water runs through the lint filter
whenever the washer agitates.
Check it often to make sure it's clean
and is filtering at its best.
To remove it for cleaning, press the
release and pull straight out. Instruc-
tions for cleaning are printed on the
bottom of the filter.
10