Washer Use; Understanding Washer Cycles; Loading; Normal Sounds - Whirlpool 3955876 Use And Care Manual

Automatic washer with catalyst cleaning action
Table of Contents

Advertisement

Available languages

Available languages

Understanding Washer Cycles

When the washer lid is closed and Cycle Control knob is set to a
number or cycle and pulled out, the washer fills (to the selected
load size) before agitation and timing start. If the CATALYST
Cleaning Action is selected, the washer spins and sprays a
detergent solution for a brief period before filling with water. The
washer will not agitate or spin with the lid open.
During agitation, the agitator creates a continuous rollover action
that provides a thorough cleaning of the wash load.
After agitation starts, the Cycle Control knob turns clockwise until
it points to an OFF area and the cycle ends.
NOTE: The washer pauses briefly throughout each cycle. These
pauses are normal for washer operation.
WASH
1.Spin-Spray
(detergent
mixture)
2.Fill
3.Wash selected
time
4.Drain - No
agitation
5.Spin
®
When the CATALYST
option
is selected, the washer spins
and sprays a detergent
solution for brief period prior
to filling.

WASHER USE

®
RINSE
1.Fill
2.Rinse
3.Drain - No
agitation
4.Spin-Spray
rinse
5.Spin
6.Off

Loading

Loading suggestions
For these suggested full-sized loads, set the LOAD SIZE selector
to the highest setting.
SUPER CAPACITY PLUS WASHERS
Heavy Work Clothes
3 pair pants
3 shirts
4 pair jeans
Delicates
3 camisoles
1 quilted robe
4 slips
Towels
10 bath towels
10 hand towels
Mixed Load
3 double sheets
4 pillowcases
8 T-shirts
6 pair shorts

Normal Sounds

Your new washer may make sounds your old one didn't. Because
the sounds might be unfamiliar, you may be concerned about
them. These sounds are normal.
During washing
When you select a small load size setting, your washer has a
lower water level. This can cause a clicking sound from the upper
part of the agitator.
If you select CATALYST
®
Cleaning Action, you will hear a spin/
spray noise at the start of the cycle.
During drain
If water is drained quickly from your washer (depending on your
installation), you may hear air being pulled through the pump
during the end of draining.
After drain and before spin
When the cycle changes from draining to spinning, you may hear
gears engaging.
1 coverall
1 overall
6 undergarments
2 sets of sleepwear
1 child's outfit
14 washcloths
1 bath mat
2 shirts
2 blouses
8 handkerchiefs
5

Advertisement

Table of Contents
loading

Table of Contents