Fitting, Removing The Multitool - Stihl FS-MM Instruction Manual

Fitting, removing the
MultiTool
Mounting the MultiTool
Remove the gearbox
1
2
1
Loosen the clamp screws (1) and
N
pull the gearbox (2) off the drive
tube.
Remove the deflector
3
4
Loosen the screw (3) and pull the
N
deflector (4) off the drive tube.
WARNING
Keep the deflector in a safe place and
always refit it before using other
MultiTools – there is otherwise a risk of
accidents.
FS-MM
1
2
Push the coupling sleeve (1) onto
N
the drive tube (2) as far as stop.
4
The coupling sleeve (1) is properly
positioned when the arrow is in line with
the gap in the flange (4).
Tighten down the wing screw (3)
N
firmly.
Removing the MultiTool
Loosen the wing screw and pull off
N
the FS-MM.
Push the deflector (1) onto the drive
N
tube (2) as far as stop.
Tighten down the screw (2).
N
Push the gearbox (3) into position
N
3 and tighten down the clamp
screws (4).
Tighten the two clamp screws on
N
the gearbox in the following
sequence:
Tighten the first screw moderately.
–
Tighten the second screw
–
moderately.
English
2
1
4
3
9