Reversing The Door Swing - Roper RT14BKXJW00 Use & Care Manual

Style 2
1. Tube Clamp
2. Copper Tubing
3. Compression Nut
3. The ice maker is equipped with a built-in water strainer.
If local water conditions require periodic cleaning or a
well is your source of water supply, a second water
strainer should be installed in the
Obtain a water strainer from your nearest appliance
dealer. Install at either tube connection.
4. Plug in refrigerator or reconnect power.
8
TOOLS NEEDED:
screwdriver, flat-head screwdriver,
wrench, flat 2-inch putty knife.
SUGGESTION: Reversing the door swing should be
performed by a qualified person.
IMPORTANT: Before you begin, turn the refrigerator OFF,
unplug it, and remove any food from door shelves.
To remove doors from hinges:
1. Keep doors closed until ready to lift free from the
2. Start at the top hinge and work your way down to the
-inch water line.
3. Open and lift doors off hinges.
NOTE: If you are reversing the door swing, you should
move the handles while the doors are off of the refrigerator.
Follow the instructions in the "Reversing the Door
Handles" section.
To replace doors on hinges:
1. Remove hole plugs covering the screw holes on the
2. Replace the doors.
3. Start at the bottom hinge and work your way up to the
4. Line up doors so they are centered between the sides
5. Fill all unused openings with screws or plastic hole

Reversing the Door Swing

-inch hex-head socket wrench, No. 2 Phillips
inch Hex-Head Hinge Screw
Door Stop Screw
Sealing Screw (use on top of doors)
cabinet.
center hinge and bottom hinge. Remove all screws and
components as shown.
opposite side of the refrigerator using a flat putty knife.
center hinge and top hinge replacing all components
and screws as shown.
of the cabinet and parallel with each other.
plugs. Moisture will enter any unfilled openings.
NOTE: If the doors are not closing on their own, see
the "Door Closing and Alignment" section.
-inch open-end