FI‐7600/FI‐7700
Cleaning the ADF (with cloth)
The ADF can be cleaned with a piece of cloth moistened with Cleaner F1, or a sheet of
Cleaning Wipe.
As the scanner continues to feed the documents, paper dust will accumulate inside the ADF
and it may cause scanning errors.
Cleaning should be performed approximately every 10,000 sheets scanned. Note that this
guideline varies depending on the types of documents you scan. For instance, it may be
necessary to clean the scanner more frequently when you scan documents on which the toner
is not sufficiently fused.
Attention
• Do not use water or mild detergent to clean the ADF.
• It may take a long time to dry if an excessive amount of Cleaner F1 is used. Use it in
small quantity.
1.
Turn off the scanner and wait for at least 15 minutes.
2.
Unplug the power cable.
3.
Open the ADF.
C
R
ONSUMABLE
EPLACEMENT AND
C
I
LEANING
NSTRUCTIONS
CG00002 ‐ 296501