Whirlpool ED25DQXDB00 Use And Care Manual page 16

The water dispenser
Chilled water comes from a tank behind the meat
drawer. It holds approximately 1 l/2 quarts (1.5 L).
When the refrigerator is first hooked up, press the
water dispenser bar with a glass or jar until you draw
and discard two or three quarts (1.9 to 2.8 L). The
water you draw and discard rinses the tank and pipes.
Allow several hours to chill a new tankful.
NOTE:
The small tray beneath the dispenser is de-
signed to evaporate
small
spills. There is no drain in
this tray.
Do not
pour water into it.
To dispense water:
1.
Press a
sturdy
glass against the water
dispenser bar.
2. Remove the glass to stop dispensing.
NOTE:
Dispense enough water every week to maintain
a fresh supply.
The dispenser light
To turn on night light,
slide dispenser LIGHT switch
to the left. See page 21 for directions for changing the
dispenser light bulb.
Solving common ice dispenser problems
PROBLEM POSSiBLE CA&/SOLUTION
Ice dispenser will
not work
l
Freezer door is open.
l
Ice bin not properly installed. Make sure the bin is pushed in all the way.
l
Wrong ice in bin. Only use crescents from the ice maker. Shake the bin
occasionally to separate cubes and increase storage room.
l
Dispenser not used for extended periods of time, causing ice cubes to melt
together. Dump old ice and make a new supply.
Ice dispenser stops
working
l
Ice dispenser bar held in too long. Wait about three minutes for dispenser
motor to reset.
l
Large amounts of ice should be taken from the bin, not through the dispenser.
15