Removing The Base Grille; Thirst Crusher'" - Whirlpool ED22RQ Use And Care Manual

Using Your Refrigerator
Continued
Removing the base grille
To remove the grille:
1. Open the doors.
2. Pull grille out as shown.
3. Do not remove Tech Sheet fastened behlnd
gnlle.
To replace the grille:
1. Line up grille support tabs with metal clips.
2. Push firmly to snap into place.
3. Close the doors.
See cleaning instructions for defrost pan and
condenser coils on page 14.
THIRST CRUSHER u dispensing system
Personal Injury Hazard
Tumbling ice and pressure on a fragile glass
can break it. Do not use a fragile glass when
dispensing ice or water. Failure to do so
could result in personal injury or breakage.
To dispense ice:
1. For cubed ice, move Ice Selector Switch to
CUBE oosltlon.
For crushed ice, move Ice Selector Switch
to CRUSHED posItIon.
2. Press a sturdy glass against the ice dispenser
bar. Hold glass close to dispenser opening so
ice does not fall outside of glass.
3. Remove the glass to stop dispensing.
NOTE: The first few batches of ice may have an
off-taste from new plumbing and parts. Throw the
ice away.
Ice is dispensed from the ice maker storage bin
in the freezer. When the dispenser bar is pressed,
a trapdoor opens in a chute between the dis-
penser and the ice bin. Ice is moved from the bin
and falls through the chute. When the dispenser
bar is released, a buzzing sound may be heard for
a few seconds as the trapdoor closes.
The dispensing system will not operate when
the freezer door is open.
NOTE: Large amounts of cubed ice should be
taken from the bin, not through the dispenser.
10