Changing The Light Bulbs; Removing The Base Grille - Whirlpool ED22DK Use & Care Manual

Refrigerator light
Condenser coils
Changing the light bulbs
Electrical Shock Hazard
Before removing a light bulb, either unplug
the refrigerator or disconnect the electric-
ity leading to the refrigerator at the main
power supply. Failure to do so could result
in electrical shock or personal injury.
To change the refrigerator light:
1. Disconnect refrigerator from power supply.
2. Reach behind the Control Console to find
bulb.
3. Remove bulb.
4. Replace with a 40.watt tubular appliance bulb.
5. Reconnect power supply.
To change the crisper light:
1. Disconnect refrigerator from power supply.
2. Pull top of light shield forward until it snaps
free.
3. Lower light shield to clear bottom supports.
4. Pull light shield straight out to remove.
5. Replace with a 40.watt appliance bulb.
6. Replace light shield in reverse order.
7. Reconnect power supply.
To change the freezer light:
1. Disconnect refrigerator from power supply.
2. Push in sides of light shield until it snaps free.
3. Replace bulb with a 40-watt appliance bulb.
4. Replace the light shield.
5. Reconnect power supply.
NOTE: Not all appliance bulbs will fit your
refrigerator. Be sure to replace bulb with one of
the same size and shape.
Removing the base grille
To remove the grille:
1. Open the doors.
2. Pull grille out.
3. Do not remove Tech Sheet fastened behind
grille.
To replace grille:
1. Line up grille support tabs with metal clips.
2. Push firmly to snap into place.
3. Close the doors.
See cleaning instructions for defrost pan and
condenser coils on page 12.
9