Sd Card Slot; Buttons; Connectors - Axis M11-E Series User Manual

AXIS M11-E Series
Specifications

SD card slot

NOTICE NO NO TICE TICE
• Risk of damage to SD card. Do not use sharp tools, metal objects, or excessive force when inserting or removing the
SD card. Use your fingers to insert and remove the card.
• Risk of data loss and corrupted recordings. Do not remove the SD card while the product is running. Unmount the SD card
from the product's webpage before removal.
This product supports microSD/microSDHC/microSDXC cards.
For SD card recommendations, see axis.com.
microSD, microSDHC, and microSDXC Logos are trademarks of SD-3C LLC. microSD, microSDHC, microSDXC are
trademarks or registered trademarks of SD-3C, LLC in the United States, other countries or both.

Buttons

Control button
The control button is used for:
• Resetting the product to factory default settings. See Reset to factory default settings on page 17.

Connectors

Network connector
RJ45 Ethernet connector with Power over Ethernet (PoE).
Audio connector
I/O connector
Use the I/O connector with external devices in combination with, for example, motion detection, event triggering, and alarm
notifications. In addition to the 0 V DC reference point and power (DC output), the I/O connector provides the interface to:
Digital input - For connecting devices that can toggle between an open and closed circuit, for example PIR sensors, door/window
contacts, and glass break detectors.
Digital output - For connecting external devices such as relays and LEDs. Connected devices can be activated by the VAPIX®
Application Programming Interface or from the product's webpage.
Note
The I/O connector is connected to the housing (fan/heater) on delivery. In case of a fan or heater error, an input signal will be
triggered in the camera. Set up an action rule in the camera to configure which action the signal shall trigger.
4-pin terminal block
23