Omron NA Series Practices Manual page 13

Screen Specifications

EtherNet/IP EtherNet/IP devices that connected to NA's Ethernet ports are detected and displayed on this screen.
Screen
1
8
13
User I/F Specifications
No Part
1 Group
2 DropDown
3 Button
4 Button
Lamp
5 Button
6 Button
7 Group
8 Button
9 Button
10 Lamp
11 DataDisplay
12 DataDisplay
13 Lamp
14 Lamp
15 Lamp
4
5
7
10
14
11
12 15
Description
The information of a device is shown. Refer to No. 9 and later for details.
You can select an NA port. Port 1 is selected by default.
Devices connected to the selected port are displayed.
Reads the configuration out.
Displays a check result of the actual and registered configurations.
When no configuration is registered, displays "Not registered."
Touched when the result is "Mismatch", the screen switches to the Network
Configuration Mismatches Window.
Enables to go to Network Configuration Registration Window.
Enables to go to Filtering Window.
Appears when the button No.３ is pressed. The dialog "Reading configurations"
blinks.
Enables you to go to the previous network configuration page. Available for 32 and
more devices.
Enables you to go to the next network configuration page. Available for 32 and more
devices.
Indicates pages for devices connected to the network. The same numbers of white
lamps as pages are displayed. A gray lamp indicates the page currently displayed.
Red lamps are for expansion and not shown in the actual NA.
Unit model is displayed.
Unit's IP address is displayed.
Indicates if the unit is included in the DLR configuration.
The indication switches to Ring Super Visor (DLR R-SV) or Ring Node (DLR RN).
Indicates a failure of the unit. Supports only GI-S Units.
Indicates a failure in the network. Supports only GI-S Units.
2
6
16
3
9
13