Mitsubishi FX3U Series Programming Manual page 526

FX /FX Series Programmable Controllers
3U 3UC
Programming Manual - Basic & Applied Instruction Edition
Related devices
Device
M8029 Instruction execution complete
M8165
Related instruction
Instruction
SORT (FNC 69)
Cautions
• Do not change the contents of operands and data during operation.
• When executing SORT2 instruction again, set to OFF the command input once.
• Limitation in the number of SORT2 instruction
SORT2 instruction can be used up to twice in a program.
• Write during RUN is disabled for a circuit block including SORT2 instruction.
• When a same device is specified in
The source data is overwritten with the data acquired by sorting.
Pay rigid attention not to change the contents of
524
→ For the instruction execution complete flag use method, refer to Subsection 6.5.2.
Name
Descending order
Sort tabulated data
This instruction sorts a data table consisting of data (lines) and group data (columns) based on
a specified group data (column) in units of line in the descending order. This instruction stores
the group data (columns) in serial devices.
S
19 Data Operation 2 – FNC140 to FNC149
19.7 FNC149 – SORT2 / Sort Tabulated Data 2
Turns ON when data sorting is completed.
Sorts data in the descending order when set to ON.
Sorts data in the ascending order when set to OFF.
Description
and
D
until execution of SORT2 instruction is completed.
S
Description