Maintenance - Eaton Verdeon Installation Instructions Manual

Photocontrol (If Equipped)
1. Using a flat blade screw driver, loosen the two
flathead screws to allow rotation of the receptacle.
(Figure 10. & Figure 11.)
2. Insert screwdriver into center slot and rotate
receptacle until indicator arrow points in desired
direction.
3. Retighten screws.
4. Insert the photoelectric control (or shorting cap) into
receptacle and twist into locked position.
The photocontrol must contain a soft, resilient gasket
N ote:
fastened to the bottom surface to assure a proper
weather seal between the control and the receptacle.

Maintenance

N ote: A regular maintenance schedule should be
followed to retain optimal light output and thermal
performance.
Optical lens cleaning should be performed with
a clean dry cloth to remove any dust or other
contaminants. Additional cleaning can be performed
with using a non-abrasive to polycarbonate cleaner.
Remove any dirt, leaves or other foreign debris from
the housing.
Installation Instructions - Verdeon/VRDN
Adjustment Slot
for North
Figure 10.
Figure 11.
EATON
IB521002EN Installation instructions
5