Installation Requirements; Tools And Parts - Whirlpool W10032070 User Manual

In the State of Massachusetts, the following installation instructions apply:
Installations and repairs must be performed by a qualified or licensed contractor, plumber, or gasfitter qualified or licensed by
the State of Massachusetts.
If using a ball valve, it shall be a T-handle type.
A flexible gas connector, when used, must not exceed 3 feet.
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools needed
Level
" drive ratchet
Tape measure
Flat-blade screwdriver
Phillips screwdriver
Hand or electric drill
Wrench or pliers
7 mm combination wrench
Pipe wrench
" (3.2 mm) drill bit (for wood floors)
" (4.8 mm) carbide-tipped masonry drill bit (for concrete/
ceramic floors)
Pipe-joint compound resistant to LP gas
Noncorrosive leak-detection solution
A child or adult can tip the range and be killed.
Connect anti-tip bracket to rear range foot.
Reconnect the anti-tip bracket, if the range is moved.
Failure to follow these instructions can result in death or serious burns to children and adults.

INSTALLATION REQUIREMENTS

Tools and Parts

WARNING
Tip Over Hazard
Parts supplied
Check that all parts are included.
A
A. Anti-tip bracket
B. Plastic anchors (2)
C. #10 x 1 " screws (2)
Anti-tip bracket must be securely mounted to subfloor.
Thickness of flooring may require longer screws to anchor
bracket to subfloor. Longer screws are available from your
local hardware store.
Parts needed
Check local codes and consult gas supplier. Check existing gas
and electrical supply. See "Electrical Requirements" and "Gas
Supply Requirements" section.
B
C
3