Table of Contents
Advertisement
If You Need Assistance
Or Sewice
This section is designed to help you save the cost of a service call. Part 1 of this section
outlines possible problems, their causes, and actions you can take to solve each problem.
Parts 2 and 3 tell you what to do if you still need assistance or service. When calling our
Consumer Assistance
Center for help or calling for service, please provide a detailed descrip-
tion of the problem, your appliance's complete model and serial numbers and the purchase
date. (See page 2.) This information will help us respond properly to your request.
1. Before
calling
for assistance
. . .
Performance
problems often result from little things you can find and fix without tools of any
kind. Please check the chart below for problems you can fix. It could save you the cost of a
service call.
PROBLEM
lothing will
lperate
POSSIBLE CAUSE
SOLUTION
The power cord is not
Plug the power cord into a live circuit
plugged into a live circuit with
with proper voltage. (See Installation
proper voltage.
Instructions.)
Range is not properly con-
Contact an authorized Whirlpool@
netted to gas supply.
service technician
to reconnect range
to gas supply. (See Installation
Instructions.)
A househokl fuse has blown
Replace household fuse or reset
or a circuit breaker has
circuit breaker.
tripped.
Controls are not set correctly.
Reset controls, if needed.
The flow of combustion and/
Remove blockage to airflow to and
or ventilation
air to the range
around range.
is blocked.
'he oven will
lot operate
The Oven Temperature
Control is not turned to a
temperature setting.
Push in and turn the Oven Tempera-
ture Control to a temperature
setting.
#urner fails to
The power cord is not
Plug the power cord into a live circuit
ight
plugged into a live circuit with
with proper voltage. (See Installation
proper voltage.
Instructions.)
A household fuse has blown
Replace household fuse or reset
or a circuit breaker has
circuit breaker. In case of prolonged
tripped.
power failure, manually light burners
(see page 8).
Burner ports are clogged.
Clean with a straight pin (see pages
18 and 22).
24
Advertisement
Table of Contents
