Whirlpool SF385PEE Use & Care Manual page 29

S
EALED SURFACE BURNERS AND COOKTOP
To clean the burners:
1.
Pull the burner cap straight up from the
burner base.
2.
Clean the burner cap with warm, soapy water
and a sponge. You can also clean it with a
mildly abrasive scrubbing pad or cleanser.
Do not clean the burner cap in a dishwasher or
self-cleaning oven.
3.
If the gas tube opening has become soiled or
clogged, use a cotton swab or a soft cloth to
clean the area.
4.
If the ports are clogged, clean them with a
R
EMOVING THE OVEN DOOR
For normal use of your range, you do not need to
remove the door. However, if you have to remove
the door follow the instructions in this section.
NOTE: If the door removal pins included in the
Anti-Tip Bracket Pakage are not available, nails or
screws may be used. Be careful that the length of
the nail or screw does not damage the oven by
chipping or scratching the porcelain surface.
straight pin. Do not
enlarge or distort the
port. Do not use a
wooden toothpick. If
the burner needs to be
adjusted, call a qualified
technician for service.
.
CONT
( )
5.
After cleaning the gas tube opening and ports,
Alignment
pin
6.
Turn on the burner to see if it will light. If the
burner does not light after you have cleaned it,
contact an authorized service technician. Do
not service the sealed burner yourself.
Insert door
removal pin here
Oven door
CARING FOR YOUR RANGE
replace the burner cap.
To replace the burner
cap, make sure the
alignment pins on
the burner cap are
properly aligned with
the burner base.
Range
Hinge
hanger
29