Cleaning Chart - Whirlpool SF378PEW Use And Care Manual

6. After cleaning the gas tube opening and
ports, replace the burner cap and burner
grate. To replace burner cap, make
sure cap is properly aligned and leveled.
Fit locating pegs into the recess in the
underside of the cap. The cap must be
correctly seated on the burner body for
proper operation of the burner.
7. Turn on the burner to determine if it will
light. If the burner does not light after
cleaning, contact an authorized
Whirlpool service technician. Do not
service the sealed burner yourself.
Locating pegs
Cleaning chart
Use the following table to help you clean your range.
PART
Control knobs
WHAT TO USE
Sponge and warm,
soapy water
HOW TO CLEAN
l
Turn knobs to OFF and pull straight away
from control panel.
l
Wash, rinse, and dry thoroughly. Do not
soak.
l
Do not use steel wool or abrasive
cleansers. They may damage the finish.
l
Replace knobs. Make sure all knobs point
to OFF.
Control panels
Sponge and warm,
l
Wash, wipe with clean water, and dry
soapy water thoroughly.
OR
l
Do not use steel wool or abrasive
cleansers. They may damage the finish.
Paper towel and spray
l
Do not spray cleaner directly on panel.
glass cleaner
Apply cleaner to paper towel.
Exterior surfaces Sponge and warm,
l
Wash, wipe with clean water, and dry
(other than control
soapy water
thoroughly.
panels)
l
Use nonabrasive, plastic scrubbing pad on
heavily soiled areas.
l
Do not use abrasive or harsh cleansers.
They may damage the finish.
NOTE: Do not allow foods containing acids
(such as vinegar, tomato, or lemon juice) to
remain on surface. Acids may remove the
glossy finish. Also wipe up milk or egg spills
when cooktop is cool.