Table of Contents
Advertisement
Solid element surface units
Burn and Electrical
Shock Hazard
Make sure all surface units are
OFF and cool before cleaning
them. Failure to do so can result
in burns or electrical
shock.
1. For best results, wipe off surface
units with a damp soft cloth and
soapy water after each use. Remove
burned-on food with a soap-filled
scouring pad. The red spot in the
center of the surface unit will
gradually wash off. This is normal
and will not affect the operation of
2.
the surface unit.
IMPORTANT:
Dry the element
completely after cleaning. Turn on
the element for a few minutes to
thoroughly dry. After the element has
cooled, use a paper towel to apply a
thin coat of salt-free oil to the surface
units to season and restore the
finish. Wipe excess oil off stainless
steel trim rings. Then heat 3-5
minutes, Some smoking may occur;
this is normal. If surface units have
dark spots caused by grease and
food, the oil treatment will improve
their appearance but not eliminate
the spots.
NOTE: Optional Electrol" dressing
can be applied to the surface units to
improve their appearance.
23
Advertisement
Table of Contents
