Push Button - Siemens RXZ90.1 Manual

Siemens
Building Technologies
Status
Installation mode
Normal mode
Receiver's device list is empty
Normal mode
Receiver's device list not empty
Normal mode
Receiver's device list not empty and
PPS2 communication not working
Status
PPS2 power supply ON
PPS2 short circuit
Pushbutton
Brief pressure <1s
Sustained pressure >5s
RXZ90.1 – Receiver with PPS2 interface
Red LED signals
Permanently ON
Rapid flashing
(approx. 5 times per s)
1 room unit: 1 flash / 5 s pause
2 room units: 2 flashes / 5 s pause
3 room units: 3 flashes / 5 s pause
4 room units: 4 flashes / 5 s pause
5 room units: 5 flashes / 5 s pause
Flashes more slowly (approx. once/s)
(e.g. during initialisation of the
controller after POWER ON)
Green LED signals
ON continuously
OFF
Action
Sets receiver to installation mode if
fewer than 5 room units in device list
Deletes the device list from the recei-
ver and then brings it to the "Normal
mode" with an empty device list.
7 / 10
CA2N1644en_05
02.08.2010