3. Pull the surface
unit straight away
from the receptacle.
Replacing
4. Lifl out the reflector
bowl and trim
ring.
See Cleaning
Chart on page
22
for cleaning
instructions.
3. Hold the surface
unit as level as
possible
with the terminal
just
started
into the receptacle.
2. Line up opening
in the reflector
bowl and notch in the trim ring
with the surface unit receptacle
I
I
4. Push the surface unit terminal
into
the receptacle.
When the terminal
is pushed
into the receptacle
as
far as it will go, the surface unit will
fit into the trim ring.
1