Before You Call For Service - Whirlpool FGS385V Care Manual

Before You Call For Service
If you are having an operating problem,
check the chart to see what the cause
might be before you call for assistance.
OPERATING PROBLEM
Nothing operates.
Oven will not operate.
Burner fails to light.
Burner flames are uneven.
CHECK IF
'Range is properly connected to gas
and electrical supplies.
. Fuse has blown or circuit breaker has
tripped.
. Control knob is set in the correct
position.
1 The flow of combustion and /or venti-
lation air to the range is blocked.
.The electronic controls are set cor-
rectly. See pages 4-7.
.YOU have programmed a delay start
time.
WHAT TO DO
m Reconnect range to gas and/or electrical
supplies. (See Installation Instructions.)
. Replace fuse or reset circuit breaker. In case
of prolonged power failure, manually light
burners (see page 4).
m Set control knob correctly, if needed.
1 Remove blockage to air flow to and around
range.
. Reset controls, if necessary.
. Range is connected to electrical
power.
n
Fuse has blown or circuit breaker has
tripped.
.Burner ports are clogged.
. Burner ports are clogged.
1 Reconnect range to electrical supply. (See
Installation Instructions.)
. Replace fuse or reset circuit breaker. In case
of prolonged power failure, manually light
burners (see page 4).
1 Clean with a straight pin (see pages 9 and 12)
. Clean with a straight pin (see pages 9 and 12)
If this fails, call an authorized RoperSM service
technician for service.
Burner flames lift off ports,
are yellow, or are noisy
when turned off.
1 Contact an authorized RoperSM service
technician to check air/gas mixture.
Burner makes popping noise
n
Burner is wet from washing. 1 Let dry.
when on.
Continued on next page
Page 14