Advertisement
Gas must flow freely through the small hole in the
brass orifice for the burner to light properly. This
area must be free of any soil and be kept
protected from boilovers or spillovers.
ALWAYS
keep
the burner caps in place whenever a
surface burner is in use.
After cleaning
the gea tube opening,
replace
the burner cap and trim ring.
Occasionally
check
the burner flames for
proper size and shape as shown. A good flame is
blue in color. If flames lift off ports, are yellow, or
are noisy when turned off, you may need to clean
the burners. II port8
are
clogged,
clean
with a
straight pin. Do not enlarge or distort port. Do
not
use a wooden
toothpkk.
lf adjustment is
needed,
call
a qualified technician for service.
U"U"
B
Typical
l
urf8ca burner flame
To replace
burner cap, make sure
cap is
properly aligned and leveled.
Find
the recessed
locating tabs on the burner cap (see illustration)
and
place
cap over the white ignitor in the burner
base.
Turn
the burner on to determine if it will light. If
the burner doer not light after cleaning,
contact
an authorized Roper service technician.
Do not service the sealed burner yourseff.
Removina
the oven door
Removing the oven door will help make it easier
to clean the oven.
Burn and Electrical
Shock Hazard
Make sure
all
controls are OFF and the oven
is cool before removing oven door.
Failure to do so can resuft in burns or
electrical shock
To remove:
1.
Open
the door as far as it will go.
2.
Remove the screws on each side of the oven
door.
3. Close
the door about % of the way.
4. Lii the door up and off the hinges.
Screw
17
Advertisement
